I have some strange problems too. I want to measure the hole with Auto Circle and the graphics of tip paths show some strange paths. If I have smaller number of hits, paths are shown on different heights, if I have a bigger number of hits (over 10) the graphics show less paths then defined, and the machine takes less points for circle (if there is 6 hits on graphics it takes 6 hits). I hope the pictures are big enough to see my problem.
So, I was literally just having this exact issue. A 2 segment 13mm hole was giving me either 5 hits, with one hit not equally spaced or it would force 3 hits, even while the dialog box was calling for 5. For some reason void detection was on. I've never turned this option on, ever. Turned it off, everything went back to normal...
So, I was literally just having this exact issue. A 2 segment 13mm hole was giving me either 5 hits, with one hit not equally spaced or it would force 3 hits, even while the dialog box was calling for 5. For some reason void detection was on. I've never turned this option on, ever. Turned it off, everything went back to normal...
