is there any way to skip hole on a cone that has flats on it? i cant get it to rotate around even when i modify the start and end angles. Also, the path lines dont match the measurement strategy. not sure what exactly is going on, maybe i am doing something wrong? I am trying to do an analog scan.
still wont work. i can use the default measurement strategy to move the hits around, but when doing the same for the adaptive cone line scan, it will not rotate. is this something that the scan will not allow? it does show the projected paths correctly except for the fact that my start and end angles are not matching.
still wont work. i can use the default measurement strategy to move the hits around, but when doing the same for the adaptive cone line scan, it will not rotate. is this something that the scan will not allow? it does show the projected paths correctly except for the fact that my start and end angles are not matching.
