Your Products have been synced, click here to refresh
I need to keep the jogbox off the table if at all possible...
And you write a second DCC alignment as well?
Can the (2nd) manual alignment be 'skipped'?... (after it has been executed once) I do use holding fixtures.
ftr, I've written this as a single program, not a paste. (Picture a 7" cube with holes 4" deep.... on all 4 sides... on a 4-5-4. :blah
So, I can only hit 2 sides at a time.
For the first time ever, I neeed Equate. And so far it's whoopin mah aff. I'm back at it in the morning.
Thanks
& also to acgarcia
I need to keep the jogbox off the table if at all possible...
And you write a second DCC alignment as well?
Can the (2nd) manual alignment be 'skipped'?... (after it has been executed once) I do use holding fixtures.
ftr, I've written this as a single program, not a paste. (Picture a 7" cube with holes 4" deep.... on all 4 sides... on a 4-5-4. :blah
So, I can only hit 2 sides at a time.
For the first time ever, I neeed Equate. And so far it's whoopin mah aff. I'm back at it in the morning.
Thanks
& also to acgarcia
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |