We recently switched from 2013 PC-DMIS TO 2017 R1 and have lost the calibration sphere data. I'm just an operator and have no idea where to start. Can someone point me in the right direction or at least tell me what we have.
Open the probe utilities dialog
Select a probe and click measure
On the bottom left corner, select ADD TOOL...
Then enter a name for the sphere, type, and shank vector IJK, and the diameter of the ball.
Select OK when you are done,
When you are ready to calibrate, select the tool you just made.
Open the probe utilities dialog
Select a probe and click measure
On the bottom left corner, select ADD TOOL...
Then enter a name for the sphere, type, and shank vector IJK, and the diameter of the ball.
Select OK when you are done,
When you are ready to calibrate, select the tool you just made.
