I am running pcdmis cad++ 3.7 mr3
I have a large number of programs that generate multiple pages of hyperview reports and save them as pdf files using the built in pdf convertor.
This has always worked fine until I decided to upgrade the computer and re-install all the software on the new computer.
now, whenever a report is generated, the resulting pdf file appears to be cut off on the bottom and on the right side, its as if the report is too large to fit within the margins so it just lops off the extra bits.
the odd thing is this only started happening when the pc was upgraded. the software version and the programs are unchanged.
I cant find where I can adjust the margins (or anything else for that matter) in the pdf convertor driver, I am assuming there must be a way?
I tried searching and there are some topics that say to check in File->Printing->Report window print settings, but that setting doesn't exist on my version of pcdmis for some reason.
I installed the cutepdf printer to give it a shot and it might work but It appears that It wont save the reports automatically to the correct folder like the built in pdf printer saves them to the same folder that the hyperview reports are located in.
some of these programs have 8+ pages of reports generated, I would have to browse to the correct folder and hit save for each subsequent report. I know its do-able but to me it seems asinine to do it that way when the built in pdf convertor doesn't require any input to generate the report.
this is an example of the code I am using for printing the hyperview report
CS7 =REPORT/FILENAME= \\BETADC1\REDIRECTEDFOLDERS\CMM\MY DOCUMENTS\CMM PROGRAMS\3878\REPORTS\3878-TRIM-SHORT.RPT, AUTOPRINT=PDF
is there a different version of the pdf convertor that I can install to fix this issue?
also, the hyperview reports are indeed within the margins of the printable area (the red rectangle), and as I said they worked correctly in the past.
