Alignment of Gear part

atul01011992 over 6 years ago

Daer all,

I am new guy for this user forum, currently I am using PC-DMIS in Camio 8.3. (Nikon Make)
Recently, I found a problem with a alignment issue for my product. It is about a alignment of [A-B I C I D-E ] of part. Please refer to attached file for details. In that A & B are the circles through which we are going to construct a 3S line as a primary datum, then moving ahead C is plane as a secondary datum and lastly D & E are tooth width, from which we need to construct a line through theirs mid points. As in that I don't understand how to do alignment of this part ?
Because there are 2 lines and 1 plane. and mostly unluckily axis of 3D line and Plane is same. Its conflicts my alignment. CAMIO is not allowing to add 2 line 1 plane alignment anyway.

Any help would be greatly appreciated.

Thank you in advance.

Best Regards,
Atul N

Attached Files

Parents

AndersI over 6 years ago

A-B - cylinder, locks two directions and two coordinates
C - plane, can't lock direction as it's the same as A-B, locks the final coordinate
D-E - line, locks the final direction (rotation)

I don't see the problem?

A1         =ALIGNMENT/START,RECALL:STARTUP,LIST=YES
              ALIGNMENT/LEVEL,ZPLUS,CYL1
              ALIGNMENT/TRANS,XAXIS,CYL1
              ALIGNMENT/TRANS,YAXIS,CYL1
              ALIGNMENT/TRANS,ZAXIS,PLN1
              ALIGNMENT/ROTATE,XMINUS,TO,LIN1,ABOUT,ZPLUS
            ALIGNMENT/END

atul01011992 over 6 years ago in reply to AndersI

Thanks @andersl for your prompt reply.

As you said,
If we lock C plane in Z axis without locking its direction, then how we supposed to lock its rotation after leveling?

Also for D-E line, how it possible to follow 3-2-1 then?

I am confused though.

It would be great if you can suggest idea.

Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

atul01011992 over 6 years ago in reply to AndersI

Thanks @andersl for your prompt reply.

As you said,
If we lock C plane in Z axis without locking its direction, then how we supposed to lock its rotation after leveling?

Also for D-E line, how it possible to follow 3-2-1 then?

I am confused though.

It would be great if you can suggest idea.

Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data