I need to move my CMM (Optiv C321) to a new location. I kmow it is recommended that I have Hexagon do it because a special pallet is needed. I have one so I want to move it myself and call on Hexagon only to calibrate. Has anybody done if yourself? Can anybody anticipate any problem with moving it myself?
We just go done moving on of our company's Global 7-10-7 from one building to another which was about a 400 yard trek through.one building, down the ramp then up the ramp and into the other building. We did tell the bosses that we did not want to be responsible for it should anything happen during the move and they were OK with that. There we 5 of us involved and everything went ok. We did install the factory bracing before moving it.
This was my 7th or 8th CMM move from one location to another. Just got to take it slow and easy and make the path is clear of obstructions BEFORE moving it.
We just go done moving on of our company's Global 7-10-7 from one building to another which was about a 400 yard trek through.one building, down the ramp then up the ramp and into the other building. We did tell the bosses that we did not want to be responsible for it should anything happen during the move and they were OK with that. There we 5 of us involved and everything went ok. We did install the factory bracing before moving it.
This was my 7th or 8th CMM move from one location to another. Just got to take it slow and easy and make the path is clear of obstructions BEFORE moving it.
