Calculation of deviation when texture is on flateness

I have aligned one part and pln-1 in Y axis origin, after pln measurement when i report flatness of pln-1 with texture on options the meas value of y axis points does not match to the deviation. Could you please explain me the are different from each other and how the deviation is calculated.

Thanks you

Parents

bfire85 over 3 years ago

Please refer the attached snap where the meas value and deviations are no matching as i have aligned that pln in y origin

First off, you are are measuring perpendicularity. The textural analysis is based off on your current alignment. If the alignment isn't leveled to H, then you'll see some different deviations. However, most likely what you are seeing if the fitting algorithm in Xact Measure.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

bfire85 over 3 years ago

Please refer the attached snap where the meas value and deviations are no matching as i have aligned that pln in y origin

First off, you are are measuring perpendicularity. The textural analysis is based off on your current alignment. If the alignment isn't leveled to H, then you'll see some different deviations. However, most likely what you are seeing if the fitting algorithm in Xact Measure.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data