Inspection of gage dimensions

Hello everyone

I need to inspect some gage on a circular part as shown in image.
1st case : Diameter should be kept constant and distance to be inspected
2nd case : Distance should be kept constant and dimeter to be inspected

how should I proceed with programming for the same?

Parents

DAN_M over 3 years ago

I would:

Workplane YMINUS

Create an alignment (Lets call it "A1") that controls 6 degrees of freedom & has the XY center of the part as the center of my alignment and the Z is the top

Then...

Measure the radius

Create Generic Line at (12.8345,0,0)XYZ/(0,0,-1)IJK. Line will intersect the radius. Construct a point at intersection of radius and line

Rotate base alignment (A1) and do it again in 4 or six places

Once done...

Recall A1

Recall ZPLUS workplane

Create a plane through all the points

Distance dimension from top to the plane
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jigars over 3 years ago in reply to DAN_M

Thanks DAN_M i was trying to create generic line at an angle (1,1,0) but due to some reason it was not constructing properly during execution.
rotating an alignment should do it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jigars over 3 years ago in reply to DAN_M

Thanks DAN_M i was trying to create generic line at an angle (1,1,0) but due to some reason it was not constructing properly during execution.
rotating an alignment should do it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data