Hello everyone
I need to inspect TP of a tapered through hole on a cylindrical surface at a distance of R. 10.4 from center of part as shown in image,
any thoughts on how this can be inspected..
is each end of the hole a different diameter? I don't think its a tapered hole, just a .250 hole drilled at a 6 deg angle. I can't see all your datums but the TP shouldn't be an issue.
The .410 on the bottom would be an intersection point from the axis of the cylinder and center of the arc?
Sorry my mistake, its an angled hole and all the diameters are same.
can we do it by neglecting arc?
as we wont be able to accurately measure center of arc
is each end of the hole a different diameter? I don't think its a tapered hole, just a .250 hole drilled at a 6 deg angle. I can't see all your datums but the TP shouldn't be an issue.
The .410 on the bottom would be an intersection point from the axis of the cylinder and center of the arc?
Sorry my mistake, its an angled hole and all the diameters are same.
can we do it by neglecting arc?
as we wont be able to accurately measure center of arc
