Hello everyone
I need to inspect TP of a tapered through hole on a cylindrical surface at a distance of R. 10.4 from center of part as shown in image,
any thoughts on how this can be inspected..
IMNSHO.... Each hole needs to have its own alignment based on the basic dimensions specified on the drawing, yes, 28 alignments including the 6° rotation and paste with pattern may not be your best option but it will work. I would use paste with pattern for the first measured feature to create the other 27 diameter measurements (including move points). Once everything has been measured, create the individual offset alignments for each hole tolerancing the position when the alignments are created. For each dimension each XYZ nominal should be zero
IMNSHO.... Each hole needs to have its own alignment based on the basic dimensions specified on the drawing, yes, 28 alignments including the 6° rotation and paste with pattern may not be your best option but it will work. I would use paste with pattern for the first measured feature to create the other 27 diameter measurements (including move points). Once everything has been measured, create the individual offset alignments for each hole tolerancing the position when the alignments are created. For each dimension each XYZ nominal should be zero
