I have to get a positional location (-A-|-B-|-C-) off a .028 diameter hole. The smallest probe (stylus) we have is .020 (.5mm)..... and of course thats , in theory, a clearance of .004 per side/radii... This does not seem to be working , because of the clearance. Does anyone know of a smaller stylus or a better way of inspecting? You know... with GD&T.... three datums.... if I use a micro-hite I am checking in two axis'. Ugh.... GD&T. Any help/ideas will be appreciated! Thanks
I have to get a positional location (-A-|-B-|-C-) off a .028 diameter hole. The smallest probe (stylus) we have is .020 (.5mm)..... and of course thats , in theory, a clearance of .004 per side/radii... This does not seem to be working , because of the clearance. Does anyone know of a smaller stylus or a better way of inspecting? You know... with GD&T.... three datums.... if I use a micro-hite I am checking in two axis'. Ugh.... GD&T. Any help/ideas will be appreciated! Thanks
If you don't have the right probe or even a Deltronic Pin, to put in there, Put it on a Comparator or Layout table, till you get either one, The CMM wasn't always around, there are other ways, to check, why your waiting for the probe or pins
hahaha! Yes... I'll let quality know that I can only inspect in two axis' because a CMM wasn't always around. What truthfully wasn't ALWAYS around is GD&T
hahaha! Yes... I'll let quality know that I can only inspect in two axis' because a CMM wasn't always around. What truthfully wasn't ALWAYS around is GD&T
