when i write a measurement routine with a scan and accompanying analysis view on my offline seat it works fine, i run it offline several times to make sure the program is good, no collisions, etc.. But when i transfer it to the online CMM computer via a server and the program gets to the "analysisview" command the program freezes. I have to go in and delete it directly on the CMM and then just generate a new one. Now this isn't catastrophic failure or anything but the CMMs are usually tied up by inspectors and machinists doing in process checks. Has anyone had an issue like this? I program with PCDmis 2022r1 but the CMMs run 2018r1. i also have 2018r2 on my offline but that still causes the same issue.
Both are valid statements, and the scan size varies from light to heavy point density. however when i delete and recreate on the online CMMs the analysis view is instantaneous. so the load on the CPU does not seem to be the factor in question. and the programs are getting moved from the server to the local CMM before running so it wouldn't be server lag either.
Both are valid statements, and the scan size varies from light to heavy point density. however when i delete and recreate on the online CMMs the analysis view is instantaneous. so the load on the CPU does not seem to be the factor in question. and the programs are getting moved from the server to the local CMM before running so it wouldn't be server lag either.
