when i write a measurement routine with a scan and accompanying analysis view on my offline seat it works fine, i run it offline several times to make sure the program is good, no collisions, etc.. But when i transfer it to the online CMM computer via a server and the program gets to the "analysisview" command the program freezes. I have to go in and delete it directly on the CMM and then just generate a new one. Now this isn't catastrophic failure or anything but the CMMs are usually tied up by inspectors and machinists doing in process checks. Has anyone had an issue like this? I program with PCDmis 2022r1 but the CMMs run 2018r1. i also have 2018r2 on my offline but that still causes the same issue.
Then it could be things getting lost in transition from Offline to Online, It took me awhile to figure out, but my Offline seat, when making any scans , when I transferred it over to Online, my scans would be perfect, couldn't figure it out, That's not possible. Then I noticed Only Selected was greyed out. Which was strange, but I uninstalled PC-DMIS and reinstalled it, and all of a sudden it was there, and any scans, from there on out was acting like it should, but sometimes to this day I might have recreate the scan, and sometimes I don't, I just find it easier to Regenerate my points in my scan before I start the program. Not a solution, but like me, might help you avoid scratching your head , making your bald spot even bigger
Then it could be things getting lost in transition from Offline to Online, It took me awhile to figure out, but my Offline seat, when making any scans , when I transferred it over to Online, my scans would be perfect, couldn't figure it out, That's not possible. Then I noticed Only Selected was greyed out. Which was strange, but I uninstalled PC-DMIS and reinstalled it, and all of a sudden it was there, and any scans, from there on out was acting like it should, but sometimes to this day I might have recreate the scan, and sometimes I don't, I just find it easier to Regenerate my points in my scan before I start the program. Not a solution, but like me, might help you avoid scratching your head , making your bald spot even bigger
