when i write a measurement routine with a scan and accompanying analysis view on my offline seat it works fine, i run it offline several times to make sure the program is good, no collisions, etc.. But when i transfer it to the online CMM computer via a server and the program gets to the "analysisview" command the program freezes. I have to go in and delete it directly on the CMM and then just generate a new one. Now this isn't catastrophic failure or anything but the CMMs are usually tied up by inspectors and machinists doing in process checks. Has anyone had an issue like this? I program with PCDmis 2022r1 but the CMMs run 2018r1. i also have 2018r2 on my offline but that still causes the same issue.
That IS odd. My best guess is that something isn't working right when you are saving the program in an older version to run on the CMMs. Maybe even the jump back from 2018R2 to 2018R1 is causing issues.
Maybe you can try saving the program as an even older version, like 2017. I have no idea if that would help, but I've done odder things to get the software to behave.
Something else that may help is to reduce the arrowdensity setting to just show 20% of the arrows or something like that. But, I think that would just help with the symptoms, not solve the main problem.
That IS odd. My best guess is that something isn't working right when you are saving the program in an older version to run on the CMMs. Maybe even the jump back from 2018R2 to 2018R1 is causing issues.
Maybe you can try saving the program as an even older version, like 2017. I have no idea if that would help, but I've done odder things to get the software to behave.
Something else that may help is to reduce the arrowdensity setting to just show 20% of the arrows or something like that. But, I think that would just help with the symptoms, not solve the main problem.
