1)Why would you include bonus on a thread? Unless the print calls the position out to the minor diameter and you line scan/max inscribe the hole (and even that is a bad idea) you should never allow bonus of a threaded feature because the pitch is where the position should be calculated, and I highly doubt you're constructing the pitch diameter.
2) What's your tolerance of your Datum B? Did you enter in a tolerance for it in your nominals tab? You're allowing over 11mm worth of Datum bonus which would lead to a perfect number (probably) every time.
Thank you everybody. So, what could be a workaround? I'm a little lost here to be completely honest. I understand the thing with the thread, I actually am measuring a circle on the head of a bolt which is mounted on the part and that bolt fits into the threaded hole of my holding fixture. I build a projected circle from the measured circle onto the plane on which the part sits and that's the circle I'm measuring position on. Tbh I can't find anything on PC-Dmis to fix this result so I don't know if it's a bad design (?)
Thank you everybody. So, what could be a workaround? I'm a little lost here to be completely honest. I understand the thing with the thread, I actually am measuring a circle on the head of a bolt which is mounted on the part and that bolt fits into the threaded hole of my holding fixture. I build a projected circle from the measured circle onto the plane on which the part sits and that's the circle I'm measuring position on. Tbh I can't find anything on PC-Dmis to fix this result so I don't know if it's a bad design (?)
