I seem to be having a problem with my circles showing oversized parameters, though the hit spots are right on the part. I have re-done the program 3 times, as well as reset measured values to nominals and I am still having this problem. This is causing my readings to be about 50,000inch out of tolerance. Any help would be greatly appreciated!
Had a broken scale on an old manual Brown and Sharpe years ago that reported a diameters form like 2 and a half miles out of tolerance. (I converted it from inches)
Had a broken scale on an old manual Brown and Sharpe years ago that reported a diameters form like 2 and a half miles out of tolerance. (I converted it from inches)