I'm trying to run a program, but I am having trouble with the manual alignment. After I do the manual alignment, the X and Z planes seem to align fine, but I'm having an issue with the Y plane. The triangles for the features line up fine on the X and Z planes on my model, but not the Y plane. That triangle is lined up at an angle, almost perpendicular to the plane. The part is set up with the A datum facing up, the B datum facing the front, and the C datum facing the left. I'm not sure what I'm doing wrong. I did not make this program, I'm only running it. Any help would be appreciated as I'm fairly new to this.
Lets just start with plane43. If you are in the MCS and took a plane straight down on to the table or part, your vector IJK would be closer to 0,0,1. Yours is showing 1,0,0 like you are taking a plane in the X direction. After creating the manual plane, are you opening it back up and editing the vector to the direction you want? because your z value hits look right.
Lets just start with plane43. If you are in the MCS and took a plane straight down on to the table or part, your vector IJK would be closer to 0,0,1. Yours is showing 1,0,0 like you are taking a plane in the X direction. After creating the manual plane, are you opening it back up and editing the vector to the direction you want? because your z value hits look right.