i have a round part with a 30.5 id and a 31.50 od with a 4 hole bolt hole pattern. when i program plane circle scan i click on jump hole . I programmed 3 circles scan with jump hole it says scan path empty. if i take jump hole off then i get a path. What am i missing.
The jump hole amount is too much. It is probably default to 25.4mm or 1 inch decrease to an amount just greater than the hole chamfer and any swelling. increase hit amount (points per mm) as well.
The jump hole amount is too much. It is probably default to 25.4mm or 1 inch decrease to an amount just greater than the hole chamfer and any swelling. increase hit amount (points per mm) as well.
i tried as you suggested no luck. i did a circle plane scan on another surface on that also has 4 holes bolt pattern but is a much bigger surface. jump hole worked.. could probe diameter have an effect? i tried all else i can think of. i was at scan training 2 weeks ago and i called the trainer. he said put in a ticket.. any suggestions would be appreciated