Evaluating roundness for cylinders (circle subitems). Roundness for first cylinder worked great, no quirks or hiccups.
Second cylinder evaluated fine too, but the subitems were wrongly named (for some reason it used the default naming scheme):
Went to create an alignment using this cylinder and the alignment dialog displayed the correct naming scheme for the subitems:
That was odd, so I set off to repeat the roundness evaluation, just to find when expanding the feature, the subitem naming were correct:
...but when trying to create the evaluation, I get the following error message:
"Feature CYLHÖ75 and it's subitems are not synchronized. Re-execute them to synchronize them again."
I'm not sure. The synchronisation error is usually seen if a feature has been partially executed but then stopped before it's complete - only executing one level of a multi-level cylinder for example - could that have been the case here?
I'm not sure. The synchronisation error is usually seen if a feature has been partially executed but then stopped before it's complete - only executing one level of a multi-level cylinder for example - could that have been the case here?