hexagon logo
Register Sign in
  • Replies 6 replies
  • Subscribers 221 subscribers
  • Views 66 views
  • Users 0 members are here
Options
Related

[2022.2 SP2] Moody GeoTol roundness (again)?

vpt.se
Evaluating roundness for cylinders (circle subitems). Roundness for first cylinder worked great, no quirks or hiccups.
Second cylinder evaluated fine too, but the subitems were wrongly named (for some reason it used the default naming scheme):



Went to create an alignment using this cylinder and the alignment dialog displayed the correct naming scheme for the subitems:



That was odd, so I set off to repeat the roundness evaluation, just to find when expanding the feature, the subitem naming were correct:



...but when trying to create the evaluation, I get the following error message:



"Feature CYLHÖ75 and it's subitems are not synchronized. Re-execute them to synchronize them again."

What happened here?

neil.challinor
Parents
  • Nope, fully executed. Also, I am not doing any measurements at all during this. It is like the feature is "lagging" behind.

    It starts with getting the subitem names wrong with "CIR1" instead of "Circle ". (pic1)
    I though it would correct itself at next execution, so I kept programming.
    Noticed that when doing an alignment on this cylinder, the subitem names in the alignment dialog was not "CIR1" anymore, but correct with "Circle". (pic2)
    Seems it now had caught up with changing the subitem names to "Circle" instead of "CIR".
    Tried with a new roundness evaluation and the subitem names were correct. (pic3)
    However, trying to actually create the evaluation, I get the synchronization error (pic4)
    Could it still be "lagging" at this point and not "caught up" to the feature?
Reply
  • Nope, fully executed. Also, I am not doing any measurements at all during this. It is like the feature is "lagging" behind.

    It starts with getting the subitem names wrong with "CIR1" instead of "Circle ". (pic1)
    I though it would correct itself at next execution, so I kept programming.
    Noticed that when doing an alignment on this cylinder, the subitem names in the alignment dialog was not "CIR1" anymore, but correct with "Circle". (pic2)
    Seems it now had caught up with changing the subitem names to "Circle" instead of "CIR".
    Tried with a new roundness evaluation and the subitem names were correct. (pic3)
    However, trying to actually create the evaluation, I get the synchronization error (pic4)
    Could it still be "lagging" at this point and not "caught up" to the feature?
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement