Evaluating roundness for cylinders (circle subitems). Roundness for first cylinder worked great, no quirks or hiccups.
Second cylinder evaluated fine too, but the subitems were wrongly named (for some reason it used the default naming scheme):
Went to create an alignment using this cylinder and the alignment dialog displayed the correct naming scheme for the subitems:
That was odd, so I set off to repeat the roundness evaluation, just to find when expanding the feature, the subitem naming were correct:
...but when trying to create the evaluation, I get the following error message:
"Feature CYLHÖ75 and it's subitems are not synchronized. Re-execute them to synchronize them again."
vpt.se Can you please send me the routine showing this behaviour? Also, are you able to reproduce the behaviour by following a certain sequence of steps or did it happen just this once?
vpt.se Can you please send me the routine showing this behaviour? Also, are you able to reproduce the behaviour by following a certain sequence of steps or did it happen just this once?
Here's the link to upload your routine:
https://sendit.hexagon.com/filedrop/~5diqk0 I'm not sure how much help it will be if it only happened once and you are unable to repeat, but we will take a look.