Hi guys
so i have this simple check program of a guage ring where i measure it with mastertip, align to it and then measure it with all the other tips in my rack.
so the other day i noticed all the tips following mastertip had a deviation of 0.01mm in Y.
so i thought maybe someone had crashed the tip and then i re calibrated all my tips.
I ran the check program again and the results were the same!
the roundness of the ring is a few microns, so no shaft hits
and the calibration results were good too, between 0.001 - 0.002 std
yup. same place, same job. This old Validator has been DCC from the beginning, with a PH9 head. We don't do 'plate layout' here as it is all stamped sheet metal, no way to do plate, so, yup, straight to the CMM programming.
yup. same place, same job. This old Validator has been DCC from the beginning, with a PH9 head. We don't do 'plate layout' here as it is all stamped sheet metal, no way to do plate, so, yup, straight to the CMM programming.