I’ve came across this problem a few times and I don’t know what I’m doing wrong or how to fix it. I have attached the Code if anyone can help. Meant to say X and Z in this program but sometimes it can be x and y. Also SLTRF is off as well.
If so, you have to remember that you are measuring that circle in the machine's coordinates, not the part coordinates. The part coordinates take affect after any alignment using part features.
Emdee Just saw this, adjust your SPACER for the plane (manual and DCC). It is set at 0. You will have poor repeatability at that. Increase it and see if there is an improvement. If not, then there might be a fixturing issue. Also as UKCMM stated, change LIN1 to 2D rather than 3D.
Emdee Just saw this, adjust your SPACER for the plane (manual and DCC). It is set at 0. You will have poor repeatability at that. Increase it and see if there is an improvement. If not, then there might be a fixturing issue. Also as UKCMM stated, change LIN1 to 2D rather than 3D.