hexagon logo
Register Sign in
  • Replies 6 replies
  • Subscribers 222 subscribers
  • Views 71 views
  • Users 0 members are here
Options
Related

PROBE TIP NOT VISIBLE FOR NEWLY INSTALLED/ALIGNED 50mm POINT PROBE 85443-03

bcotter@bannermetalcraft.
BOUGHT A NEW 50mm PROBE-POINT-MULTI GAGE 85443-03. USED ON ABSOLUTE 85 ARM RUNNING PC_DMIS 2020R1/ RDS 5.4
WENT THROUGH THE ALIGNMENT PROCEDURE OF A NEW PROBE IN RDS. RESIDUAL ERROR AND CALCULATION RESULTS ARE WITH IN SPEC LIMITS.

ABLE TO INSERT PROBE INTO A PROGRAM BUT THE GRAPHICS SCREEN SHOWS ONLY THE BASE OF THE PROBE AND NOT THE TIP. SEEING THE PROBE TIP ON THE SCREEN COMPARED TO THE PART IS THE WHOLE IDEA OF THE GRAPHICS SCREEN.

DID HEXAGON PROPERLY PROGRAM THIS PROBE CORRECTLY??? IT IS A PURCHASED PROBE FROM HEXAGON AND SHOULD WORK COMPLETELY

SEE ATTACHED 3mm PROBE WITH TIP VS POINT PROBE WITH OUT TIP

ANY IDEAS ?
Parents Reply
  • in reply to BIGWIG7
    IT'S NOT SHOWING A TIP TO CLIP...ONLY THE DESCRIPTION NAME I GAVE IT.
    THE EDIT PROBE COMPONENT BOX OPENED BUT IT SHOWS THE DRAW THIS COMPONENT BOX IS CHECKED.
    HEXAGON ASSURED ME THAT I WOULD ONLY NEED TO ALIGN IT...NOT BUILD IT.

    I HAVE A 2ND POINT PROBE (PACKAGE DEAL) AND A 2mm BALL STYLUS THAT I WAN'T TO SWAP ONTO IT. NOT EVEN GOING TO BEGIN TRYING TO FIGURE THAT OUT.

    ANYWAY, THANKS FOR THE ASSIST.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement