Today after manual alignment DCC is off by .05 in Y. Code below.
Are there any other settings that could be throwing things off?
Issues with auto features to watch for?
Tried shelling it and it didn't fix the problem.
COMMENT/OPER,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,
TAKE 3 HITS ON DATUM -A- (TOP OF PART)
MAN_Z =FEAT/CONTACT/PLANE/DEFAULT,CARTESIAN,NONE,LEAST_SQR
THEO/<0.852,-0.1382,0.263>,<0,0,1>
ACTL/<0.852,-0.1382,0.263>,<0,0,1>
TARG/<0.852,-0.1382,0.263>,<0,0,1>
ANGLE VEC=<1,0,0>,RADIAL
SHOW FEATURE PARAMETERS=NO
SHOW CONTACT PARAMETERS=NO
COMMENT/OPER,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,
TAKE 4 HITS ON LEFT MOST Ø.110 THRU
MAN_LEFT =FEAT/CONTACT/CIRCLE/DEFAULT,CARTESIAN,IN,LEAST_SQR
THEO/<0.151,-0.214,0.263>,<0,0,1>,0.11
ACTL/<0.151,-0.214,0.263>,<0,0,1>,0.11
TARG/<0.151,-0.214,0.263>,<0,0,1>
START ANG=0,END ANG=360
ANGLE VEC=<1,0,0>
DIRECTION=CCW
SHOW FEATURE PARAMETERS=NO
SHOW CONTACT PARAMETERS=NO
COMMENT/OPER,NO,FULL SCREEN=NO,AUTO-CONTINUE=NO,
TAKE 4 HITS ON RIGHT MOST Ø.110 THRU
MAN_RIGHT =FEAT/CONTACT/CIRCLE/DEFAULT,CARTESIAN,IN,LEAST_SQR
THEO/<2.503,-0.214,0.263>,<0,0,1>,0.11
ACTL/<2.503,-0.214,0.263>,<0,0,1>,0.11
TARG/<2.503,-0.214,0.263>,<0,0,1>
START ANG=0,END ANG=360
ANGLE VEC=<1,0,0>
DIRECTION=CCW
SHOW FEATURE PARAMETERS=NO
SHOW CONTACT PARAMETERS=NO
MAN_LIN1 =FEAT/LINE,CARTESIAN,UNBOUNDED,NO
THEO/<0.151,-0.214,0.263>,<1,0,0>
ACTL/<0.151,-0.214,0.263>,<1,0,0>
CONSTR/LINE,BF,3D,MAN_LEFT,MAN_RIGHT,,
OUTLIER_REMOVAL/OFF,3
FILTER/OFF,WAVELENGTH=0
MAN_ALIGN =ALIGNMENT/START,RECALL:STARTUP,LIST=YES
ALIGNMENT/LEVEL,ZPLUS,MAN_Z
ALIGNMENT/ROTATE,XPLUS,TO,MAN_LIN1,ABOUT,ZPLUS
ALIGNMENT/TRANS,XAXIS,MAN_LEFT
ALIGNMENT/TRANS,YAXIS,MAN_LEFT
ALIGNMENT/TRANS,ZAXIS,MAN_Z
ALIGNMENT/END
MODE/DCC
Attached Files
