I am having trouble with a CMM at my new shop. I have never had this problem with any other machines prior to this one. When I open the program, there is a message that says "Offnen" which means "Open." I can close the message, but then it pops up again after about 5 seconds. I can preview the recent programs, but it does not let me open them. I tried turning everything off and on, and unplugging all of the chords and plugging them back in. It keeps happening after about 2 days now. Contacted Hexagon, but they take forever to respond. Has anyone had this problem before?
bfire85 We do have a USB plugged in, but it was plugged in when the issue occurred. I did switch the port it was plugged into. Did nothing. And yes, we have been running it under the current license. Just happened randomly when i attempted to run a program.
bfire85 We do have a USB plugged in, but it was plugged in when the issue occurred. I did switch the port it was plugged into. Did nothing. And yes, we have been running it under the current license. Just happened randomly when i attempted to run a program.