I don't know what this true position on the hole is constraining. Bolt circle diameter or orientation of the hole maybe? Trying to determine if I need to measure the hole as a cylinder. Appreciate the help.
It's essentially the hole pattern to itself.
Probably will have to a manual alignment using two of the bolt holes to offset before going to DCC.
Create a cylinder on Datum A, then level and set the origin on it.
Measure the bolt hole circles and do a 2D best fit rotary alignment. (Terminology may not be correct.)
Then report the position of the bolt hole circles.
And our job is to inspect part like it was manufactured. Too many times a designer designs the component one way, it's made a another way & it's checked yet another way. No wonder all the bickering going one back & forth.
And our job is to inspect part like it was manufactured. Too many times a designer designs the component one way, it's made a another way & it's checked yet another way. No wonder all the bickering going one back & forth.