So then I went and re-calibrated and grabbed a gage block and made the attached program. I measured the front plane of the gage block and it related the A0B0 and A-90B0 correctly, but the plane on the back of the gage block using -90B180. It measures Y=76.802 instead of Y=76.200 so off by 0.6mm on the rear plane. Then I did the front plane with A90B180 and it was measuring at -0.3mm. I calibrated all tips and the probe results, are added. Did I forget to calibrate something or is something off with my wrist? Anyone have ideas as to what is going on or what I could have missed?
Attached Files