Vector Point On Hit Error

We have a part with the hole below. The hole is allowed to be flashed over to 0,3mm. I wanted to use a Vector Point to check for a Flash Panel. But there is no On Hit Error available, encase someone has cleared the flash before the part goes on the CMM.

Is it possible to use another feature type to check this?

This is what I'd like to do:-

Part has flash probe hits and is within 0.3mm Tol CMM carries on running and is reported OK
Part has flash probe hits and is above 0.3mm Tol CMM Stops with a warning and is reported NOK
Part has no flash CMM carries on running and is reported OK

TIA

James

Attached Files

Parents

JNeville89 over 1 year ago

Another day, another try

Getting it to measure and record a result now for flash and no flash

But my nominal value keeps changing based on there being flash or no flash should be z -12.76 ±0.30

What have i done wrong now...

See attached cant post code

Attached Files

FT Hole Code.txt
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JNeville89 over 1 year ago

Another day, another try

Getting it to measure and record a result now for flash and no flash

But my nominal value keeps changing based on there being flash or no flash should be z -12.76 ±0.30

What have i done wrong now...

See attached cant post code

Attached Files

FT Hole Code.txt
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

KatmandudaMeow over 1 year ago in reply to JNeville89

only dimension the point if there is flash.
see attachment below
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel