Here is my problem. If I say I only want to report 3 digits and .005+/-.001 and the result is .0061 it will show me a fail. I want it to show me a pass. Same with .0039 want to show as a pass.
Anything in the software that I can turn on to correct the pass fail with that?
Any thoughts would helpful can think of some work arounds.
When you set your displayprecision to 3, the screen would show the tolerance of ±.001, but it could be set for ".00149" however be sure your nominal value is set properly, or you will still get the miscellaneous flags you are trying to avoid.
Personally, I feel it's bad practice but, if your establishment has rules to handle trailing values then you should be within the written rules by setting your tolerances up this way.