We got a Hexagon SwiftCheck fixture and program recently. I went to run the program on one of the CMM's on the shop floor and when I went to calibrate the special 4x20 probe that came with it, it gave me this funky error message. It wouldn't let me click "OK" and acknowledge the error (it kept popping back up), so my only alternative was to click "shutdown" and it effectively killed PC-DMIS. When PC-DMIS came back up, it wouldn't let me open any programs (they were grayed out). This happened in both operator and online mode. This really freaked me out! The only saving grace was that a complete shutdown of both the CMM and the PC attached and when I rebooted them both, everything worked out ok. See error message below. How can I disable temperature compensation/correction so this doesn't happen again? Do I do it in the program or in settings?
The routine is meant to be executed through Inspect. You can choose whether to run with or without tempcomp from the SwiftCheck settings page. The way the routine works is that there are a number of assignments at the start which determine how it runs. These assignments are dynamically populated by Inspect each time you execute.
The routine is meant to be executed through Inspect. You can choose whether to run with or without tempcomp from the SwiftCheck settings page. The way the routine works is that there are a number of assignments at the start which determine how it runs. These assignments are dynamically populated by Inspect each time you execute.
