I am using a 0.7X20mm probe (long thin shaft). What are the best calibration settings for this probe? It keeps failing calibration for a few tip angles (.0004 deviation). I am using DCC+DCC 31 hits (5 levels) with a start angle of 10 and end angle of 90.
This mostly depends on shaft diameter and material, but when things get very flakey, or if you have a thin part: touchspeed 1.0, Max force 0.024N, Low force 0.012N, Upper force 0.02N, Trigger force 0.016N
This mostly depends on shaft diameter and material, but when things get very flakey, or if you have a thin part: touchspeed 1.0, Max force 0.024N, Low force 0.012N, Upper force 0.02N, Trigger force 0.016N
Yep. We have .5mmx20mm probe that gets qualified at 1% touch speed Renishaw PH10T. At the other CMM that's got scanning head .5x45mm gets qualified at 0.5% speed because we notices significant bending during calibration. It works well now.