I have been asked to measure lead on a cylindrical machined surface. Is PC-DMIS capable of this measurement, and if so how would you go about programming the measurement?
You could measure the area with no lead as a circle, then measure the extreme end of where the lead is allowed to be as a circle. do an assignment to subtract the difference in diameters, divide by 2 and report that if I'm understanding you correctly.
You could measure the area with no lead as a circle, then measure the extreme end of where the lead is allowed to be as a circle. do an assignment to subtract the difference in diameters, divide by 2 and report that if I'm understanding you correctly.