I have been asked to measure lead on a cylindrical machined surface. Is PC-DMIS capable of this measurement, and if so how would you go about programming the measurement?
did I sketch everything correctly?
however, either the starting point as a diameter or the length of this "lead" is still missing.
if you have all the normal values then you can measure an auto-cone there quite normally.
If you don't have all the normal values available, measuring is pointless anyway
did I sketch everything correctly?
however, either the starting point as a diameter or the length of this "lead" is still missing.
if you have all the normal values then you can measure an auto-cone there quite normally.
If you don't have all the normal values available, measuring is pointless anyway