Command argument out of limit

Hi,
I am getting an error message "Command argument out of limit" whenever i try to ctrl+e a single feature of a program after the program has ran through fully. It is happening with all current programs. I feel another employee has changed a setting, has anyone ever had this issue before?

Thanks

Parents

BIGWIG7 over 1 year ago

^ BaigZadeh can you run the program from the beginning, then stop it in the middle, and then continue the program again?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
BaigZadeh over 1 year ago in reply to BIGWIG7

Yeah I feel a setting has been changed by someone somewhere, as I had a problem with calibration yesterday where A0B0 would calibrate fine then any other angle for any probe would miss the sphere by a lot, and after hours of digging noticed the probe head orientation had been changed for A90B180 from Y+ to Y-.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

BaigZadeh over 1 year ago in reply to BIGWIG7

Yeah I feel a setting has been changed by someone somewhere, as I had a problem with calibration yesterday where A0B0 would calibrate fine then any other angle for any probe would miss the sphere by a lot, and after hours of digging noticed the probe head orientation had been changed for A90B180 from Y+ to Y-.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data