I am trying to inspect a part where the critical dimension is a hole in the middle with a diameter of 25.476mm (+0.01/-0), and it also has a 0.01mm cylindricity callout. When I inspect the hole as a cylinder, both the UAME and Local sizes are reporting out of tolerance, however when I inspect the same hole as multiple circles at different depths, all of the circles are in tolerance. Instead of using the auto cylinder function, I also tried to create a construction cylinder out of those circles and still got the same result. The cylindricity itself is in tolerance, as well as the runout, so I'm not exactly sure what I am doing wrong, and what i can do to correct this. I am relatively new to CMM programming, so any advice is appreciated.
Location is reporting size with the same filters as you measures the circle (asualy Least Square) and in the GD&T function you have to select "Least Square" for how it calcultes size.
Location is reporting size with the same filters as you measures the circle (asualy Least Square) and in the GD&T function you have to select "Least Square" for how it calcultes size.