Good morning. Thaks for reading. I'm trying to measure a square slot on a cylinder. However, the slot is 'pitched up' on one side as to where the probe styli is taking the hits. The ruby makes great contact with the other side. I was cycling thru the options and I couldn't find anything for adjusting its 'pitch'. Would I have to just make some lines and create the feature?
Or is there a way to 'pitch' the auto square slot. Thanks for your time.
Using PC DMIS Command Mode...
-make square slot
-get the code into your edit window
-open the code up to show the hits
-type in different "z values" to make your own pitch
Using PC DMIS Command Mode...
-make square slot
-get the code into your edit window
-open the code up to show the hits
-type in different "z values" to make your own pitch