I am using a TP-20. I got a new tip size we havent used before (.7mm x 20mm ). I built a new probe file it is correct except HP-TB-2 is not in the list anymore, so i am using a HP-TBe. I have done this with other tip builds without a problem. When i try to calibrate all the tip angles over half come up with the error probe diameter exceeds limits, i try re-running those angles but get same results any suggestions?
standard dev. .000394 tip diameter .009843 . and i am using a standard module (yellow) I use this module with my .5mm x 20mm tip and don't have any problems although the shank on that tip is reinforced half way down so the working area of tip is closer to 10mm. I am also having the same problem with the other new tip we got (1mm x 27.1mm) We generally use a 1mm x 20mm or a 1.5mm x 30mm tip for most parts, never had a issue. But these are the only 2 new tips i have built since updating the software to 2023.1 are there any changes or issue with this version? The list of tool or hardware names seems to have changed
standard dev. .000394 tip diameter .009843 . and i am using a standard module (yellow) I use this module with my .5mm x 20mm tip and don't have any problems although the shank on that tip is reinforced half way down so the working area of tip is closer to 10mm. I am also having the same problem with the other new tip we got (1mm x 27.1mm) We generally use a 1mm x 20mm or a 1.5mm x 30mm tip for most parts, never had a issue. But these are the only 2 new tips i have built since updating the software to 2023.1 are there any changes or issue with this version? The list of tool or hardware names seems to have changed
