I've got a real problem with the DEMON changing the number of hits in a scan, programmed offline vs. being ran online. My real issue is pulling hits from these scans for intersect points on short surfaces. It there a way to lock this up so the hits are what I programmed it to or do I need to get my program changed. Picture a small piece of pie (each side approximately 7mm long) with chamfers on the 3 corners at 0.65mm to 0.7mm. Running the program offline produced exactly what I the CAD/print shows and I've been beating my head against the wall (run this through Inspect so I saw no data) tryin to get this figured out.
maybe "defined" for execution mode? that's about all I can give you, and I'm not sure what it will do to the path, will it stay a scan scan or a stitch scan.
