I've got a real problem with the DEMON changing the number of hits in a scan, programmed offline vs. being ran online. My real issue is pulling hits from these scans for intersect points on short surfaces. It there a way to lock this up so the hits are what I programmed it to or do I need to get my program changed. Picture a small piece of pie (each side approximately 7mm long) with chamfers on the 3 corners at 0.65mm to 0.7mm. Running the program offline produced exactly what I the CAD/print shows and I've been beating my head against the wall (run this through Inspect so I saw no data) tryin to get this figured out.
Neil that just sucks (pardon my attitude) but if I define a scan around "my pie" offline and when I run it online it changes what it does based on the deviation of the surface. I find it odd that when I tolerance the form (best fit profile tolerance) of "my pie" it is within 0.02 to 0.050mm of CAD nominal and the DEMON detects this deviation and change the whole scan. This is not acceptable.
Neil that just sucks (pardon my attitude) but if I define a scan around "my pie" offline and when I run it online it changes what it does based on the deviation of the surface. I find it odd that when I tolerance the form (best fit profile tolerance) of "my pie" it is within 0.02 to 0.050mm of CAD nominal and the DEMON detects this deviation and change the whole scan. This is not acceptable.
