Hi all, recently we only use clearance cube as it works perfect for our complex parts. We do not waste any time, however I did notice that collision detection is not working properly. It shows a lot of errors where actually the program will work fine. It look like the collision detection does not recognize the clearance cube. Any solution ?
Clearance cube has it quirks, just like the rest of PC DMIS. You can make your programs more efficient by turning it off and on for individual features as needed. If you have a row of holes to measure you turn ift on for approaching the first hole, turn it off for all but the last hole, turn it back on for exiting the last hole. To me, they should have had Clear Cube on/off show up in the code instead of in a separate table. I'm not currently running 2023 so I don't know how much of an improvement was made.
Clearance cube has it quirks, just like the rest of PC DMIS. You can make your programs more efficient by turning it off and on for individual features as needed. If you have a row of holes to measure you turn ift on for approaching the first hole, turn it off for all but the last hole, turn it back on for exiting the last hole. To me, they should have had Clear Cube on/off show up in the code instead of in a separate table. I'm not currently running 2023 so I don't know how much of an improvement was made.
