Any thoughts as to why this error keeps coming up? Only when dropping off a probe, not picking up. Happens for every probe change. Hit play and and the probe change continues on. I've went through and re-taught each position(3). Picks-up with no issues.
So after 3 continuous loops without error, loop 5 errored out for each probe again. Changed the before and after setting to 75 from 60 and executed with a probe change necessary at the beginning. So far all 3 probes changed without issue. Just weird how this started after updating to newer versions.
If it makes it through all 5 loops without error I'll call this resolved.
There might be a "timeout" for the pick/place commands embedded in the backend of the software. Or the probe sensor is triggering a fault after x seconds.
See if your touchspeed and/or jogbox speeds have an impact.
There might be a "timeout" for the pick/place commands embedded in the backend of the software. Or the probe sensor is triggering a fault after x seconds.
See if your touchspeed and/or jogbox speeds have an impact.
