DEV SHOW "- Sign" but OOT shows + sign .how tochange OOT - SIgn

where are you from Karupp? 

India

FASCINATING! Have you had formal PCDMIS training? 

FASCINATING! Have you had formal PCDMIS training? 

During machine installation   I had trained that time we did not discuss above Subject 

did you search for the answer before you posted the question? Because the search feature is pretty good if you just keep trying different search tactics. 

Here is a possible answer to your question. 

 Changing Negative Nominals to Positive 

I would suggest next time you have a question try the search bar on the front page. 

+1

Pl.see below image y positive nominal.OOT is negative.pl.support

That’s the way it’s supposed to be. The Z is over sized so there’s no Negative sign. However the Y is undersized so there’s a negative. That’s exactly what you need to see. The report is right. To get rid of the negative sign, make the part correct to print!!!

Pl see.below image.Y is underside but OOTis positive..Pl support  how to become negative sign?

OOT is positive because it's a total number. the TOTAL deviation is a value of .49

IF deviation + SIGN , OOT  ALSO SHOULD BE SAME SIGN WHAT TO DO?

F10

DESELECT> OOT

BIGWIG7