Use Pin should be set to NO because it's already modeled as an Outside Diameter. The depth is the distance from the nominal height that the hits are taken at (PC-DMIS defaults to whichever end of the cylinder you clicked closest to when selecting the cylindrical face). You should also turn off the Void Detection toggle, as this can mess up the spacing of the hits and cause the Depth function to work incorrectly.
Greetings! Thank you for reaching out to the PC-DMIS community page.
May I know from which region you are based out of? I would like to connect with you directly and get the issues resolved. From your posts, I sense a high requirement ofPC-DMIS product + Metrology Domain training.
Looking for your revert!
Best Regards,
Krishna Chaitanya VELISETTY Senior Manager – Global Technical Support
