Scan paths broken after execution

That's really weird.  I can't say I've seen that before.  It looks like the points density is modulating somehow. 

My best guess is that the surface is too rough for that probe, and it is kind of skipping along the surface.  Maybe try reducing your scanning acceleration value so it can better compensate?  If that doesn't do it, maybe try a larger probe diameter.  

Thank you for the reply

Do you have have any filtering turned on?  My guess is those points are being automatically filtered out as erroneous points.

That would make sense.  I have seen that happen if a scan is set to find nominals from the model and some of the hits fall outside of the nominals tolerance.  Typically, this will stop the CMM and display an error message where it asks if you want to change the nominals tolerance. But someone may have clicked the "don't ask me again" buttons on those prompts in a way that would set the defaults to automatically delete any points for which nominals can't be found. 

No filtering is turned on. We did run another part and changed the stylus size from 3mm to 5mm and seems to have helped. Its strange though because the surface is pretty smooth. I'll continue to see if it gets any better and post results. Thank you everyone for the feedback its much appreciated.