Hello all
I got a call for flatness of a cylinder. When I check the cylinder, I check with 3 cycles and 6 hits each 180 degrees a cycle. What should I do to get the call? Thank you
Hello all
I got a call for flatness of a cylinder. When I check the cylinder, I check with 3 cycles and 6 hits each 180 degrees a cycle. What should I do to get the call? Thank you
Thank you both.
The designer would like to control 2 wires' flatness to a surface ( One wire about datum B and the other wire is datum C), but could not find the right way to clarify it.
