un-even profile tolerance

Yes...I cannot figure out how to change it from +/- .0105 to +.013/ -.008....  I could alway just figure out the nominal at +.013 & -.008.... crazy. I have seen tolerances like this before though.

What version of PC-DMIS are you using? If you are using GeoTolerance in version 2020 R2 and above, there is this.

2014....sry... meant to state this earlier

hmmm.... and of course we have 2014. I don't recall a 'U'....for an option

If I find this "uneven" tolerance symbol, then it must be self explanatory on how to add the un-even tolerance. ??  Then again, maybe with the 2014 we do not have that option?

So since that is possibly legacy and not GeoTol, the only way you can do un-even profile tolerance is using Form and Location. Form only will split it evenly.

If you choose form only, it will remove the minus tolerance and give you an error message about tolerance.

Thanks William! You're the bestest!  Have not had 'legacy' on in some time.  Appreciate it!!!!  This Forum is the BEST

I am not 100% sure if Xact dimensioning worked the same way, since I never had the pleasure of using it. Glad to be of help.

I am not 100% sure if Xact dimensioning worked the same way, since I never had the pleasure of using it. Glad to be of help.