Auto-Calibration - Can I set it so that my tip does not index to A0B0 at the end?

See if this helps...

Auto Calibration Program - Centering Probe Before Wrist Angle Changes - PC-DMIS for CMMs - PC-DMIS - Nexus Community (hexagon.com)

I believe he posted that and the question may have been answered in there as well. I am not entirely sure if he has tried what NinjaBadger said about changing the tip before the autocalibration command to something that is not TIP/T1A0B0 be what he wants it to be after it autocalibrates.

Yes I've tried that and it works, I'm just curious if there's a way to keep it from indexing at all at the end of an auto calibration. I'm pretty sure there's not because I've looked it up a bunch but I wasn't sure if someone might know something about it.

WOW... I didn't even notice that!  I just remembered the post from a few days ago and referenced it without looking at the author!  Forgive me Cole, my alcohol is low!! LOL

Haha no problem man.

I've not tested it, but you could try untick 'Reset Global Settings when branching' from the general  tab in Setup (F5).

I'm not sure if the AutoQual command classes as branching.

*Note: if you use flow control already in your programs this could impact on those programs.