How save and recall alignment works

Ok, so this is my test part and after deleting this points, manually measuring i created new points and it works ok. 

But how to write program when i'm only offline parts have to come in next two months but i should write program now 

How to make it good without problems with bad calculations ? 

Start an offline program with recalling an external alignment even if it does not exist yet. Repeat the alignment in DCC mode by programing all the hits on the datums (offline) still. Continue with your program. When you have the parts, create a manual calibration program and save the alignment with the name that you recall in your main routine. Obviously test this before waiting months on a simple dummy program and a part you already have (can be another part/product code all together).

Start an offline program with recalling an external alignment even if it does not exist yet. Repeat the alignment in DCC mode by programing all the hits on the datums (offline) still. Continue with your program. When you have the parts, create a manual calibration program and save the alignment with the name that you recall in your main routine. Obviously test this before waiting months on a simple dummy program and a part you already have (can be another part/product code all together).